NOT SUITABLE FOR:

Not suitable for PE, PP, PTFE, bitumen, mirrors, natural stone, permanently moist places and for attaching a non-porous material on a non-porous substrate. When gluing plastics always perform an adhesion test first. Adhesion to plastics can vary depending on the type of synthetic and the quality of the plastic.

HANDLING

BEFORE USE:

Working conditions

Only apply at temperatures between +5°C and +40°C.

Surface requirements

Both parts must be dry, clean and free of dust and grease. One of the two parts must be porous (absorbent).

Tools

Use putty knife or spatula to apply. If necessary, use a rubber mallet to tap lightly. For surface bonding use a glue spreader (2 mm).

Coverage

Wall covering sheets and panels: about 5-8 m²/kg depending on the weight of the material. Lathing, skirting boards and timber framework: about 4-6 m²/kg glued surface.

DURING USE:

Handling of packaging

Before using, pierce the tube membrane with the puncture point integrated into the cap.

Directions for use

Depending on the weight of the material, apply the adhesive evenly in strips or dots at intervals of between 20 and 30 cm. Always apply adhesive to the corners and along the edges. For surface bonding apply adhesive thinly and evenly on one side using a glue spreader. Assemble materials with a pushing movement and press or knock firmly together. Correction is still possible. For heavy materials fasten or support where necessary.

AFTER USE:

Stains/residue

Use water for cleaning tools and removing wet adhesive residue. Dry adhesive residue can only be removed mechanically.

Storage conditions

Close container properly and store in a dry, cool and frost-freeplace.